Contacts
Address
United Kingdom, England, Sheffield, S48LN, 395 Petre Street
Director
Manager
Phones of enterprise
management
+44
When placing an order please inform the manager that you've learned the information on Allbiz! Thank you that you buy on Allbiz!
Internet
Site:
About enterprise
Daver Steels, Ltd.
Daver Steels manufacture high strength structural tie rods and components with a high specification finish for architectural applications.
Our DST520 tie rod system is produced in carbon and stainless steel, both with characteristic yield strengths of 520 N/mm2.
The DST520 system provides a technical solution to your tie rod requirements.We have a wide range of experience with tie rod systems and can offer assistance to architects, designers and the end user.
For rapid installation on site, DST520 tendons are pre-assembled in the factory and set to their nominal pin-to-pin length. The tendons are then ready for immediate incorporation into the structure and generally require no site assembly, saving valuable time.
As well as our standard range of fittings shown in this website, Daver Steels are happy to manufacture to your specific needs.
In stock
Threaded fork ends are used to terminate bars and transfer load to the structure. Fork ends are cast components from M12 - M100. The forks are threaded left hand or right hand depending on the tie rod arrangement and are generally tapped with a blind hole for corrosion detailing.
Group: Shaft fixings
In stock
Bar specification: Grade 520 bars to Daver Steels
Specification. Please call our technical department for further details
Group: Machines and the equipment for construction service of bridges and tunnels
In stock
Where tendons cross in a braced bay a central connection disc can be used. Bars and forks are generally threaded left hand/right hand for the central discs. Tendons are usually fork to fork type but where longer adjustments are required, or a pre-tension is required, fork-turnbuckle-fork can be...
Group: Rope-ways
In stock
Tendons longer than 12m will be split into transportable lengths and some site assembly will be required. Ensure all components are fitted to the bar and the nominal pin-to-pin length has been set. Follow the steps below: Back off turnbuckle locking thread coversInstall tie rods and pins, tighten...
Group: Rope-ways
In stock
For rapid installation on site DST520 tendons are pre-assembled in the factory and set to their nominal pin-pin length. The tendons are then ready for immediate incorporation into the structure and generally require no site assembly, saving valuable time. To install follow the steps below. Back off...
Group: End fittings
In stock
Certain applications may require tendons to be pre-stressed after installation. This can be performed provided jacking turnbuckles have been specified. Daver Steels can offer a robust and easy-to-use range of jacking equipment to provide a simple solution to the stressing of tendons which can be...
Group: End fittings
